Recommended Links:Lamination and Coating Line
1. Gravure Coating
The gravure coating process relies on an engraved roller running in a coating bath that fills the roller's engraved dots or lines with coating material.

2. Reverse Roll Coating
Reverse Roll Coating In this process, the coating is metered onto the coating roller by precisely setting the gap between the upper metering roller and the coating roller below it.

3. Knife-Roll Coating "Gap Coating"
This process relies on the coating being applied to the substrate and then passing through the "gap" between the "knife" and the support roller. As the coating and substrate pass, the excess is scraped off.

4. Meyer Rod Coating
In this coating process, excess coating is deposited on the substrate as it passes through the bath roller. The desired amount of coating is allowed to remain on the substrate.

5. Slot die (slot, extrusion) coating
In the slot die process, the coating is extruded through a slot by gravity or under pressure and onto the substrate.

6. Dip (dip) coating
In this simple process, the substrate is dipped into a coating bath, which usually has a low viscosity to enable the coating to return to the bath as the substrate emerges.

7. Curtain Coating
In the curtain coating process, a bath with grooves on the base allows a continuous curtain of coating to fall into the gap between two conveyors.

8. Air Knife Coating
A simple process where the coating is applied to the substrate and the excess is "blown off" with a powerful jet of air knife.











