1. Generally speaking, before each start-up of the extruder, we should carefully and carefully check whether there are foreign matters in the barrel, up and down the hopper and inside, check whether the fastening bolts at each part are loose, whether the safety cover is firm, and whether the position of each button switch is correct, and then add enough lubricating oil at each lubricating part to clean the equipment.
2. When preparing to start up, inform the staff around the equipment.
3. Start the motor for driving screw rotation at low speed, and check whether the pointer of the working ammeter of the main motor swings normally. In case of abnormal sound during equipment operation or unstable screw operation, stop the machine immediately and find relevant personnel for maintenance.
4. The screw idling test run shall not exceed 30min. After everything is normal, install the mold for production products and the connecting bolts for mold installation. Before use, apply a layer of molybdenum disulfide or silicone oil to facilitate disassembly.
5. At the initial stage of feeding production, the screw shall be used at a low working speed, and the feeding shall be less and uniform. Check whether the pointer of the working ammeter of the motor driving the screw rotation swings abnormally at any time.
6. After the extruder is put into normal production, the operator shall regularly check the temperature change of the bearing. When checking the temperature of the motor and each bearing part, gently touch the inspection part with the back of your finger. Do not touch any rotating parts with hands during equipment operation.
7. When disassembling and installing screws and moulds, it is not allowed to directly knock the parts with a heavy hammer. If necessary, hardwood shall be padded before knocking for disassembly or installation.
8. When cleaning the residues on the screw, barrel and mold, bamboo or copper knives and brushes must be used. It is not allowed to scrape the residues with steel knives or barbecue parts with fire.
9. When handling extruder failure, the extruder shall not be started. When the extruder screw rotates and the die is adjusted, the operator is not allowed to face the extrusion barrel mouth to prevent accidents.
10. The operator is not allowed to leave the post during the production of the extruder. If it is necessary to leave, the extruder shall be stopped.
11. Dismantle the screw after shutdown, and apply a layer of antirust oil after cleaning the residual materials. If it is not used for the time being, wrap it up and hang it vertically in a dry and ventilated place.
12. For extruders and molding dies that have been shut down for a long time, anti rust oil shall be applied and all outlet orifices shall be sealed to prevent foreign matters from entering.







